Back

Do's and Don'ts

DO...

  • design the installation to allow for ground movement after the installation.
  • keep the hose free from all objects and debris.
  • measure to insure proper length of connector has been selected.
  • handle and store the connectors carefully before an installation.
  • follow all printed instructions included with the connectors, if provided.
  • note the minimum bend radius as specified.
  • install flexible connectors so that the bend is as close to the center of the connector as possible.
  • if provided, keep the painted lay line straight and on the centerline of the connector.
  • use a wrench only on the hex flats.
  • use the manufacturer's recommended cathodic protection system or dielectric isolation boot, if provided.
  • check for leaks before covering the installation.

DON'T...

  • use a wrench or any other tool on the hose or braid collar.
  • twist or torque the hose.
  • over-bend a flexible connector beyond its minimum bend radius.
  • install a flexible connector with the bend next to the end fittings.
  • attempt to stretch or compress a flexible connector to fit an installation.
  • restrict flexibility by allowing a connector to come into contact with other components or equipment during an installation.
Wrongwayrightway